Filter
Top Products
- 24 -
4. KEY OPERATION FUNCTIONS
4.1 SYSTEM MODE FUNCTIONS
The system mode has the following functions for the printer self-test and setting various parameters.
For details, refer to Key Operation Specification (TAA-1379).
(1) Self-test
• Maintenance counter/various parameters printouts
• Automatic self-test
• Head broken dots check
(2) Various parameters settings
• Character code selection
• Selection of font 0
• RS-232C communication speed
• RS-232C data length
• RS-232C stop bit length
• RS-232C parity
• RS-232C transmission control
• Language for LCD messages
• Forward feed standby
• Forward feed standby action
• Head-up operation in cut issue mode or the use of the rewinder in batch issue mode
• Installed solenoid type setting
• Use of ribbon saving system
• Control code
• Peel-off wait status selection
• [FEED] key function
• Kanji code selection
• Euro code setting
• Automatic head broken dots check
• Centronics ACK/BUSY timing setting
• Web printer function setting
• Reset process when the nInit signal is ON
• Ribbon near end detection setting
• Expansion I/O operation mode
• Centronics operation mode
• Plug-and-play operation mode
• Label end/ribbon end process setting
• Pre-peel-off process setting
• Back feed speed setting
• MaxiCode specification setting
• Print head type setting
• System mode password operation setting
• XML specification setting (supported by V4.4A and Xx.x only)