Filter
Top Products
- 275 -
LED Indication
No.
LCD Messages of
Upper line
(English)
POWER ON LINE ERROR
Printer Status
Restoration
by the
[RESTART]
key
Yes/No
Acceptance
of Status
Request
Reset
Command
Yes/No
18 Display of error
command
(See NOTE 1.)
{ z {
A command error has occurred
in analyzing the command.
Yes Yes
19
POWER FAILURE
{ z {
A momentary power interruption
has occurred.
No No
20
INITIALIZING...
{ z z
The memory card is being
initialized.
(Initialization is carried out for
a
max. of
approximately 15
seconds)
– –
21
EEPROM ERROR
{ z {
An EEPROM for back-up cannot
be read/written properly.
No No
22
SYSTEM ERROR
{ z {
When any abnormal operations
as below are performed, a
system error occurs.
(a) Command fetch from an odd
address
(b) Access to the word data
from a place other than the
boundary of the word data
(c) Access to the long word
data from a place other than
the boundary of the long
word data
(d) Access to the area of
80000000H to FFFFFFFFH
in the logic space in the user
mode.
(e) Undefined command placed
in other than the delay slot
has been decoded.
(f) Undefined command in the
delay slot has been
decoded.
(g) Command to rewrite the
delay slot has been
decoded.
No No
23
100BASE LAN
INITIALIZING...
(This is spread over the
upper and lower lines)
{ z z
The 100BASE LAN is being
initialized.
* When the B-9700-LAN-QM
(built-in 10/100BASE Ethernet
interface board) has been
installed.
– –
24
DHCP CLIENT
INITIALIZING...
(This is spread over the
upper and lower lines)
{ z z
The DHCP client is being
initialized.
* When the DHCP function is
enabled.
– –