Filter
Top Products
- 27 -
Parameter Initial Value
Print density fine adjustment
(Direct thermal print mode) (Key)
0
Ribbon motor drive voltage fine adjustment
(Rewind)
(Key)
0
Ribbon motor drive voltage fine adjustment
(Back tension) (Key)
0
X-coordinate fine adjustment (Key) 0 mm
Transmissive sensor manual threshold fine
adjustment value
1.4 V
Reflective sensor manual threshold fine
adjustment value
1.0 V
Type of character code PC-850
Font of 0 “0” (without slash mark)
Communication speed 9600 bps
Data length QP type 8 bits
QQ type 8 bits
CN type 8 bits
Stop bit length 1 bit
Parity QP type NONE
QQ type NONE
CN type NONE
Flow control QP type XON/XOFF + READY/BUSY (DTR) protocol:
(XON output when the power is on, XOFF
output when the power is off)
QQ type READY/BUSY (DTR) protocol
CN type XON/XOFF + READY/BUSY (DTR) protocol:
(XON output when the power is on, XOFF
output when the power is off)
Language for LCD messages QP type English
QQ type English
CN type English
Forward feed standby after an issue OFF
Forward feed standby action MODE 1
Head-up operation in cut issue mode, or use of
the rewinder
OFF
(Head-up operation is not operated./
the rewinder is not used.)
Installed solenoid type setting TYPE 2 (TDS-16A: Stronger pull force type)
Use of ribbon saving system B-SX4T OFF
B-SX5T
ON (When the head lever position is
“TAG”.)
Type of control code Auto
Peel-off wait status selection OFF
[FEED] key function FEED (One label is fed.)
Kanji code TYPE1
Euro code B0H
Automatic head broken dots check OFF
Centronics ACK/BUSY timing setting TYPE 1
Web printer function OFF
Reset process when the nInit signal is ON ON
Ribbon near end detection setting OFF
Expansion I/O operation mode TYPE1