Filter
Top Products
- 231 -
C: Stored PC command save file
SOH STX “C” Slot
Stored PC command save file name
ETX EOT CR LF
01H 02H 43H xxH
File name 1 00H File name 2 00H ··· File name n
00H
03H 04H 0DH 0AH
In the following cases, 1 byte of “00H” is returned as the stored PC command save
file name.
c There is no file.
d The ATA card has not been inserted in the specified slot.
(2) This command is one of the command types that are processed as they are
received. Processing takes place starting from the ones received first. Until the
process of the command previously sent is completed, this command is not
processed. Therefore, if the printer is not in the idle state when this command is
sent, the information data may not be returned immediately.
Note (1) This command is effective only for the serial interface (RS-232C).
File name (including extension):
“00H” should be placed between file
names.
Slot:
“1” (31H): Slot 1
“2” (32H): Slot 2