Filter
Top Products
Modbus 485 and Modbus IP Protocols - Thermal Management Products
77 Liebert
®
IntelliSlot
®
Modbus/BACnet IP
HW/HG Hrs Exceeded 10087 — 1 — —
Hum Hrs Exceeded 10088 — 1 — —
Dehum Hrs Exceeded 10089 — 1 — —
Network Failure 10091 — 1 — —
No Connection W/Unit 10092 — 1 — —
Unit(s) Disconnected 10093 — 1 — —
Unit Code Missing 10094 — — — —
Unit Code Mismatch 10095 — — — —
Call Service 10096 — — — —
Low Memory 1 10097 — — — —
RAM / Battery Failure 10098 — — — —
HCB not connected 10099 — — — —
(Parallel Flash) Memory 1 Fail 10100 — — — —
(Serial Flash) Memory 2 Fail 10101 — — — —
Customer Input 1 10104 — — — —
Customer Input 2 10105 — — — —
Customer Input 3 10106 — — — —
Customer Input 4 10107 — — — —
Digital Scroll Compressor 1 Sensor Fail 10108 — — — —
Digital Scroll Compressor 2 Sensor Fail 10109 — — — —
Low Int Temperature 10110 — — — —
High Ext Dewpoint 10111 — — — —
Cabinet Temp Sensor Fail 10112 — — — —
Cabinet Humidity Sensor Fail 10113 — — — —
Ambient Temp Sensor Fail 10114 — — — —
Comp 1 Short Cycle 10132 — — — —
Comp 2 Short Cycle 10133 — — — —
Reheat Lockout 10140 — — — —
Humidifier Lockout 10141 — — — —
Compressor(s) Lockout 10142 — — — —
Fire Alarm 10148 — — — —
Heaters Overheated 10149 — — — —
Condenser 1 Failure 10150 — — — —
Condenser 2 Failure 10151 — — — —
Humidifier Cylinder Worn 10152 — — — —
Heat Rej VFD 10153 — — — —
Heat Rej TVSS 10154 — — — —
Humidifier Low Amps 10155 — — — —
FC Lockout 10156 — — — —
Water Leak Sensor Fail 10157 — — — —
Reference Document: ST100I&C PA Parameters and Events, Version 18.0
If the Scale column has a value for a Data Description, divide the Modbus value by the value in the Scale column to get the
scaled value.
1. Any non-recognized alarm code by current firmware received from the DS control will trigger this event.
Table 23 Liebert DS
™
and Liebert PeX
™
- Status and Coil (continued)
Controller Liebert iCOM
™
v3
Data Description
Status Coil
Number
of Bits Scale Notes / Units