Filter
Top Products
Figure 5-5 Custom Paper Size dialog box
Name
Use the Name text box to type a new name for a custom media size.
The name that appears in the Name text box depends on the following conditions:
●
If a saved custom media size has been selected from the drop-down menu on the Paper/
Quality tab, then the Name text box shows the name of the selected custom media size.
●
If a standard media size has been selected on the Paper/Quality tab, then the Name text box
shows the default name of "Custom."
●
If a new name has been typed into the Name text box for the purpose of saving a new size or
renaming an existing size, then that new name will remain in the text box until the new size is saved
or the dialog box is closed.
If you type a new name into the Name text box, but then do not click Save, you can change the width
and height values without losing the name. However, if you close the dialog box without clicking Save,
any unsaved name or size values are lost without warning.
Paper size
The width and height values can be changed by typing numeric strings into the edit boxes in the Paper
Size group box.
Any entry that is greater than the maximum limits of the width and height control is rounded down to the
maximum valid entry, while any entry that is smaller than the minimum limits of the width and height
control is rounded up to the minimum valid entry.
If units are in millimeters, the custom media-size range minimum is the limit rounded up to the nearest
whole millimeter. The custom media-size range maximum is the limit rounded down to the nearest whole
214 Chapter 5 HP PCL 6, PCL 5, and PS emulation unidrivers for MS Windows ENWW
HP unidrivers for
Windows