Filter
Top Products
121
Print Material Guidelines
• Use labels that can withstand temperatures of 205°C
(401°F) without sealing, excessive curling, wrin-
kling, or releasing hazardous emissions.
• Do not print within 1 mm (0.040 in.) of the edge of
the label, of the perforations, or between die-cuts of
the label.
• Do not use label sheets that have adhesive to the
edge of the sheet. We recommend zone coating of
theadhesiveatleast1mm(0.040in.)awayfrom
edges. Adhesive material will contaminate your
printerandcouldvoidyourwarranty.
• If zone coating of the adhesive is not possible, a
3 mm (0.125 in.) strip should be removed on the
leading and driver edge, and a non-oozing adhesive
should be used.
• Remove a 3 mm (0.125 in.) strip from the leading
edge to prevent labels from peeling inside the
printer.
• Portrait orientation is preferred, especially when
printing bar codes.
• Do not use labels that have exposed adhesive.
• You may feed vinyl labels from the 250-sheet input
tray and the multipurpose feeder.
After continuously printing approximately 10,000 pages
of labels (or each time you replace the print cartridge),
complete the following steps to maintain printer feeding
reliability:
1 Print 5 sheets of paper.
2 Wait approximately 5 seconds.
3 Print 5 more sheets of paper.