Filter
Top Products
209
Installing Memory Options
6 Insert the option card straight into the connector
as shown.
Make sure the edges of the card fit into the slots
located on each of the connector latches.
Note: This illustration is for the
Optra M410. The connector for
the Optra M412 is inverted.
Invert the option card to insert it.
7 Push in on one side of the card and push in one of
the latches until it snaps into place. Repeat for the
othersideofthecard.
Make sure each latch fits over the notch located on
either side of the option card.
8 Repeat steps 4 through 7 to install another mem-
ory option card in one of the memory connectors.
Otherwise, go to step 9.
9 Continue with “Installing an Option Card” on
page 216 if you have other option cards to install.
Otherwise, go to “Closing the Printer System
Board” on page 220.
Notch
Latch