Filter
Top Products
79
Operator Panel Menus
PCL Emul Menu
Use the PCL EMUL MENU to change printer settings that
only affect jobs printed using the PCL emulation printer
language.
PCL Emul Menu
Menu Item Values
Font Source Resident*
Download
Flash
Disk
All
The Font Source setting determines which fonts appear in the Font Name menu.
If a font source is not installed or does not contain any fonts, it is not listed as a value. Fonts
are loaded and stored on the flash memory option.
See “Understanding Fonts” on page 231 for more information.
Font Name Font position and font name for all fonts in the selected font source (displays on both lines of
the operator panel)
(R0 Courier*)
After you select a font source, choose the specific font from the Font Name menu item. The
printer displays the font source abbreviation, font ID, and font name for each font. The font
source abbreviation is
R for resident, F for flash, K for disk, and D for download.
Note: Always select the correct
Font Source before you select the Font Name.
To print a font sample list showing all the fonts available for PCL emulation, see “Printing a
Font Sample List” on page 242.
Point Size
(only displays for
PostScript or
typographic fonts)
1…1008 (in increments of 0.25)
(12*)
Point size
refers to the height of the characters in the font. One point equals approximately
1/72 of an inch.
If you chose a scalable typographic font, you can select the point size for the font. You can
select point sizes from 1 to 1008 in increments of 0.25 points. See “Pitch and Point Size” on
page 232 for more information.
*Factory default