Filter
Top Products
149
Using the Multipurpose Feeder
Using the
Multipurpose
Feeder
After loading print material in the multipurpose feeder,
select the paper source from your software application,
and then select the paper size and type from both your
software application and from the operator panel.
Note: Software settings may
override operator panel settings.
To set the operator panel:
1 Make sure the PAPER SIZE for the multipurpose
feeder (
MP Feeder Size) is set to the correct size for
the print material you are loading.
2 Make sure the PAPER TYPE for the multipurpose
feeder (
MP Feeder Type) is set to the correct value
for the print material you are loading.
3 Make sure the PAPER LENGTH for the PAPER TYPE
in the multipurpose feeder is set to the correct
value for the print material you are loading.
Print material 152.4 mm (6 in.) or less in length must
exit to the rear output bin. See “Using the
Rear Output Bin” on page 134 for more information.
4 Press Go to return the printer to the Ready state.