Filter
Top Products
221
Closing the Printer System Board
4 Hold the side door slightly to the left of the printer
and place the latches located on the back edge of
the side door against the metal shield.
The edge of the metal shield fits into the latches. The
top latch fits inside the back of the printer.
5 Close the side door, pressing on the side door
latches to snap it into place.
6 Close the upper and lower front doors.
7 Reconnect all cables to the back of the printer.
8 Reconnect the printer power cord to the printer
and a properly grounded electrical outlet.
9 Turn the printer power On (|).
10 Make sure the Ready message appears on the oper-
ator panel display.
If an error message appears, see “Understanding
Printer Messages” on page 151.
Note: To verify options are
installed properly, see “Verifying
the Installation of Options” on
page 229.