Muratec MFX-2830 All in One Printer User Manual


 
FAX
Chapter4
FAX Chapter4
Fax Settings
3-196
Other settings list
Function Description Setting
# of Redials
This sets the number of times for redial attempts when the destination
line is busy. The interval between redial attempts is set at “Redial Inter-
val”.
2-15 times: 2 times
Redial Interval
This sets the interval between redial attempts. 1-5 minutes: 1 min-
ute
Block Junk Fax
(see page 3-156)
This function enables you to block receipt of unnecessary faxes. Re feren ce: Page
3-156
# of Rings
This sets the number of times the machine will ring before fax reception
when the reception mode is set to Fax or Tel/Fax.
When in the Low Power mode, the number of rings will be more than the
number set.
Note
1-10 times: 2 times
Set DRD
(see page 3-136)
Set this to “ON” when using DRD.
There are eight ring patterns, A to H. Select the setting most suited to
your usage conditions.
OFF
A~H: A
Dialing Pause
This sets the default for the dialing interval (2-10 seconds) when the
pause symbol is input.
2-10 seconds: 2 sec-
onds
High Resolustion
This sets the dpi for resolution when a document is scanned for S-fine
transmission. If 600 dpi is set, the scan is sharper than with 400 dpi;
however, it may result in memory overflow when the document is sent.
600dpi
400dpi
Rx Reduction Rate
Select from “Auto”, which automatically selects the magnification accord-
ing to the length of the document being received, or “100%” to have all
faxes printed out at the same rate of reduction.
Auto
100%
Reduction Margin
(see page 3-50)
This sets at what point the document printout will extend to the follow-
ing page if the document being received cannot fit within the effective
recordable area.
0.0-3.3 inches: 1.5
inches
Paper Saving
(see page 3-51)
This sets the print method for documents received.
If it is set to “H-Page Rx” and 2 pages of Letter, Legal or 11
"
×17
"
are re-
ceived in succession, the two pages will be reduced at the appropriate rate
and printed out on one piece of paper.
If it is set to “Duplex Rx”, both sides of each sheet of paper will be used for
printouts.
A duplex print unit is required for duplex reception.
Note
OFF
H-Page Rx
Duplex Rx
Rotate Tx
An Letter document can be rotated on its side, scanned and sent as
Letter size. The “Rotate Tx” setting is only effective with memory trans-
missions.
Letter
Letter
Transmit
ON
OFF
Quick Memory Tx
If this is set to “ON”, fax transmission for multiple documents will begin
in order of page when it has been scanned and stored.
ON
OFF
Underlined items are the factory default.