Muratec MFX-2830 All in One Printer User Manual


 
In This Case...
Maintenance and Troubleshooting
Getting
Started
COPY
Chapter1
COPY
Chapter2
COPY
Chapter3
FAX
Chapter1
FAX
Chapter2
FAX
Chapter3
FAX
Chapter4
Common
Settings
In This
Case...
Appendix
5-31
Error Message
Error message Countermeasure
Reference page
Please set up Security Rx Attempting the security reception without setting. Perform the se-
curity reception setting first.
3-88
Received document stored Attempting to cancel Security reception when a Security reception
document is present.
Print the received document.
3-90
Scanner in use One or more of the following operations was attempted when the
scanner was in use. Wait until the scanning finishes before at-
tempting the operation.
· Transmission to a different destination.
· Storing a document reserved for polling.
· Attempted to change the resolution or contrast.
Security reception document pres-
ent
During security reception. Print the received security reception
document.
3-90
Selected address is invalid The recipient for the reserved transmission has not been regis-
tered yet.
Set Fax/Tel Ready Mode · Attempting to turn on all fax forward settings in Tel mode. Fax
forward cannot be used in Tel mode.
· Call forward cannot be used in this reception mode. When using
call forward, set the reception mode to Fax/Tel or Tel/Fax.
1-54
Set individual forwarding numbers
first
No recipient has been registered for fax forwarding, or no regis-
tered recipient has been set to On. Set at least one recipient On for
forwarding faxes.
3-80
Set ratio below 400% A ratio more than 400% was specified for enlarge transmission ra-
tio. Reset the number between 100% and 400%..
3-132
The value entered exceeds the limit
Please enter a value within the list
range
The entered ratio is incorrect. Enter the correct ratio again. 3-132
Too many characters Names or numbers were entered exceeding the maximum limit.
Re-enter within the maximum number of characters.
Too many locations The number of department codes exceeded 100.
Up to 100 department codes can be registered.
4-14
To stop transmission
Press FAX CANCEL key
Pressed STOP during fax transmission. Cancel the transmission by
FAX CANCEL/JOB CONFIRM.
3-28