Filter
Top Products
12 - 14
12
e-STUDIO350/352/353/450/452/453
DEVELOPMENT SYSTEM
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
(5) Remove 1 bearing on the rear side and take
off the mixer-2.
*Replacement of Oil Seal ( Page 12-15)
Fig. 12-524
[I] Toner cartridge drive unit
(I-1) Toner cartridge drive unit
(1) Take off the toner cartridge.
(2) Take off the developer unit
(
Chapter 12.5 [A]).
(3) Take off the receiving tray
( Chapter 2.5.1[H]).
(4) Take off the tray back cover
( Chapter 2.5.1 [I]).
Fig. 12-525
(7) Remove 2 screws and disconnect 2 connec-
tors. Then take off the toner cartridge drive
unit.
Fig. 12-526
(5) Disconnect 1 connector and remove 1 har-
ness clamp.
(6) Remove 3 screws and take off the toner
cartridge cover.
Bearing
Oil seal