Filter
Top Products
Caution : Dispose of used batteries and RAM-ICs including lithium batteries according
to this manual.
Attention : Se débarrasser de batteries et RAM-ICs usés y compris les batteries en
lithium selon ce manuel.
Vorsicht : Entsorgung der gebrauchten Batterien und RAM-ICs (inklusive der Lithium-
Batterie) nach diesem Handbuch.
• Use suitable measuring instruments and tools.
• Avoid exposure to laser radiation during servicing.
- Avoid direct exposure to the beam.
-Donotinserttools,parts,etc.thatarereectiveintothepathofthelaserbeam.
-Removeallwatches,rings,bracelets,etc.thatarereective.
• Unplug the power cable and clean the area around the prongs of the plug once a year or more.
Aremayoccurwhendustliesonthisarea.
3. Main Service Parts for Safety
• The breaker, door switch, fuse, thermostat, thermofuse, thermistor, etc. are particularly
important for safety. Be sure to handle/install them properly. If these parts are shorted circuit
and/or made their functions out, they may burn down, for instance, and may result in fatal
accidents. Do not allow a short circuit to occur. Do not use the parts not recommended by
Toshiba TEC Corporation.
4. Cautionary Labels
• During servicing, be sure to check the rating plate and the cautionary labels such as “Unplug
the power cord during service”, “Hot area”, “Laser warning label” etc. to see if there is any dirt
on their surface and whether they are properly stuck to the equipment.
5. Disposition of Consumable Parts, Packing Materials, Used batteries and RAM-ICs
• Regarding the recovery and disposal of the equipment, supplies, consumable parts, packing
materials, used batteries and RAM-ICs including lithium batteries, follow the relevant local
regulations or rules.
6. Reassembly of disassembled parts is the reverse of the disassembly unless otherwise
noted in this manual or other related documents.
Care should be taken that small parts, such as screws, washers, pins, E-rings, star wash-
ers, harnesses are not installed in the wrong places.
7. Basically, the machine should not be operated with any parts removed or disassembled.
8. Precautions Against Static Electricity
• The PC board must be stored in an anti-electrostatic bag and handled carefully using a wrist-
band, because the ICs on it may become damaged due to static electricity.
Caution: Before using the wristband, pull out the power cord plug of the equipment and
make sure that there are no uninsulated charged objects in the vicinity.
07/06