Toshiba 350 All in One Printer User Manual


  Open as PDF
of 302
 
2 - 39
2
e-STUDIO350/352/353/450/452/453
OUTLINE OF THE MACHINE
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
[E] Switching power supply
(1) Take off the left cover ( Chapter 2.5.1 [J]).
(2) Remove 2 screws. Disconnect 2 connectors
with lock on the front side and 1 connector
while releasing the harness from the holder
on the right side of the bracket.
Fig. 2-551
(D-2) e-STUDIO352/353/452/453
(1) Take off the hard disk with the whole brack-
ets. ( chapter 2.5.1 [B])
(2) Disconnect 4 connectors.
Fig. 2-548
Fig. 2-550
07/11
SYS board
(3) Remove 8 screws and take off the SYS
board.
Note:
Alternatively, you can take off the SYS board
without removing the hard disk by removing
2upperand1lowerxingscrewsforthe
harddiskbracketand1xingscrewforthe
ground wire to tilt down the hard disk toward
you.
Fig. 2-549
 previous next