Filter
Top Products
13 - 23
e-STUDIO350/352/353/450/452/453
FUSER UNIT / PAPER EXIT SECTION
13
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 13-729
(4) Remove 2 screws and take off the thermo-
stat from the holder.
Fig. 13-730
Fig. 13-731
Notes:
When installing, pay attention to the follow-
ings.
1. Makesuretoxthethermostat,andthen
harness terminal in order on the holder.
2.
Make sure that the fuser roller is pressed to
the pressure roller when adjusting the gap
between the fuser roller and thermostat
with the screw A to be 1.5 mm to 1.9 mm.
[M] IH control PC board (IH board)
(M-1) IH board
(1) Take off the IH terminal cover
( Chapters 2.5.1 [L]).
(2)
Take off the right rear cover
(
Chapter 2.5.1 [P]).
(3) Take off the SYS board with the whole case
( Chapter 2.5.2 [C]).
(4)
Remove 3 screws and take off the IH board
cover.
Screw A
Fig. 13-728
[L] Thermostat
(1) Take off the exit unit ( Chapter 13.7 [F]).
(2) Release the harnesses of thermostat from 3
harness clamps.
(3) Remove 2 screws and take off the thermo-
stat with the whole holder.