Filter
Top Products
Windows NT/LAN Server Configuration 7-7
speaking, you should use the service BINARY_xx
(where "xx" is the P1 for the first parallel port, S1 for
the first serial port, P2 for the XConnect 100 second
parallel port, and S2 for the XConnect 100 second
serial port) to pass the data through unmodified.
LAN Server/Warp Server Configuration
TROY XCD print servers will work with IBM LAN Server/
Warp Server networks that have IBM TCP/IP V2.0 or later
software installed on the file server (TCP/IP is standard with
LAN Server V4.0 and later, and on Warp Server). Use the
following procedure to configure the TROY XCD print server
on an OS/2 LAN Server or Warp Server file server, or on a
OS/2 Warp Connect workstation:
Important: TROY XCD recommends TCP/IP for OS/2
printing because it is routable and provides higher
performance. Some TROY XCD print server models also
support OS/2 printing using the NetBEUI or DLC/LLC
protocols (refer to Chapter 1 for specific protocol support
information). OS/2 configuration using these protocols is
described in Chapters 9 and 10 of this manual.
1. Make sure that TCP/IP software is installed on your
OS/2 file server. If you have not already done so, open
the TCP/IP folder on the desktop, and double click on
the TCP/IP Configuration icon to add the IP address
to the OS/2 file server (consult your system manager
for this address).
2. Add the TROY XCD print server name to the HOSTS file
(usually located in the \tcpip\etc directory; this step is
not required if you use the TROY XCD print server IP