Filter
Top Products
Troubleshooting 14-19
to work (in the case of ULTRIX, the case of the letters
must also match exactly).
2. If you are using DECprint Supervisor (DCPS) make sure
that the printer is forced into PostScript mode (DCPS
will not work with printers in auto language switching
mode and will not work with PCL-only printers).
3. Make sure LAT is enabled for outgoing connections. For
VMS, enter LATCP and type SHOW NODE at the Latcp>
prompt. The display should show Outgoing
Connections Enabled.
If it does not, you should type
SET NODE/CONNECTIONS=BOTH. If you are using
ULTRIX, make sure that you have started LAT with the
lcp -s command and that you have enabled host-
initiated connections with the lcp -h command.
4. Make sure that there are no duplicate LAT node names or
LAT port numbers. Try changing the node name to a
different name and/or creating a different LAT port to fix
the problem. Also avoid having multiple print queues
that use the same LAT port.
5. If you are running ULTRIX, make sure that the
/etc/printcap file is typed in correctly. In
particular, look for missing ":" and "\" characters,
because a small error anywhere in the file can have major
consequences. Also check the /usr/spool directory
to make sure that you have created a valid spool
directory.
6. If you are running ULTRIX, check your tty device to
make sure that :