Filter
Top Products
5-18 Novell Network Configuration
- Go to Print Queues, press Insert to create a new
print queue, and enter the name of the print queue.
If you are configuring an NDS queue, you will also
need to enter a volume name (press Insert to
browse for available volumes).
- Select Print Servers (NetWare 4.xx and later) or
Queue Servers (NetWare 2.xx and 3.xx), press
Insert and enter the name of the TROY XCD print
server (the default print server names are discussed
in the Default Print Server Names section at the
beginning of this manual).
- Go to Print Queues, select the desired print
queue, then select Print Servers and press Insert to
select the name of the TROY XCD print server.
- Exit PCONSOLE.
4. Go back to XCONFIG and enter the command:
SET NETWARE RESCAN
After a few seconds, do a SHOW NETWARE
command; you should see the queue you created being
serviced by the file server. You are now ready to use
the queue.
Configuring the Print Server and Adding
the Print Queue in Remote Printer Mode
To configure a TROY XCD print server for remote printer
mode, there are two basic steps required. First, you must use