Filter
Top Products
Management Methods 3-7
at the UNIX system prompt, where ipaddress is the IP
address of the print server. When you are connected, push
RETURN or ENTER to get the "#" prompt, enter the
password ACCESS (it will not print), and type anything in
response to the Enter Username> prompt. When you get
the Local> prompt, you are ready to enter commands.
XCONFIG. To connect to the print server using the TROY
XCD XCONFIG NetWare utility, insert the TROY XCD
Print Server Software diskette in Drive A and type:
A:XCONFIG
at the DOS system prompt (or choose the appropriate path if
you are running XCONFIG from your CD-ROM or hard
drive). If you have only one print server, you will be
immediately connected. If you have more than one print
server, you will be given a list of available print servers.
Type the number of the print server to which you want to
connect. When you are connected, enter the password
ACCESS (it will not print) at the "#" prompt, and type
anything in response to the Enter Username> prompt.
When you get the Local> prompt, you are ready to enter
commands.
Serial Port. To connect to the print server using the serial
port, refer to Chapter 2 for details on how to use this port.
Once you have established a connection, press RETURN or
ENTER to get the Local> prompt (no password is required).
You are now ready to enter commands.
HP JetAdmin
TROY XCD print servers work transparently with the HP
JetAdmin utility. You can download JetAdmin from the HP
web site (http://www.hp.com). Use the Windows Run