Filter
Top Products
2-10 Installation
6 7 8 9
DE9 Male
(female pinouts are in
reverse order)
XConnect 100 (DE9) Printer (DB25)
DE9 DTE DCE
pin Signal Signal pin pin
1 Not used Not used - -
2 Receive Data Transmit Data 2 3
3 Transmit Data Receive Data 3 2
4 DTR out DSR in 6 20
5 Signal Ground Signal Ground 7 7
6 DSR in DTR out 20 6
7 RTS out CTS in 5 4
8 CTS in RTS out 4 5
9 Not used Not used - -
Basically, the cable must connect input signals (e.g., Receive
Data) on the TROY XCD print server to the equivalent
output signals (e.g., Transmit Data) on the device and vice-
versa.
If you are connecting a printer to the second serial port (S2)
on the XConnect 100, you must first disable console mode on
that port. This is done by using the console command SET
PORT S2 CONSOLE DISABLED
and then typing the command
EXIT to exit the console (refer to Chapter 3 and Appendix A
for information on using the console). To re-enable the
console function, you must either enter the command SET
PORT S2 CONSOLE ENABLED
using TELNET, DEC MOP or
the TROY XCD XCONFIG NetWare utility, or reset the unit
back to factory defaults.