Filter
Top Products
5-22 Novell Network Configuration
NOTE: If you want to enable remote printer
capabilities on services other than the default NetWare
services, you must define new services that are enabled
for NetWare and for the desired port (only one service
per port can be defined for NetWare). Refer to Appendix
B in this manual for information on how to do this.
14. Select the Remote Printer as the Operating Mode,
enter the name of your PSERVER NLM as the Print
Server Name, and select the number of the printer
from step 6 as the Printer Number (XAdmin32 and
JetAdmin allow you to choose from a list of available
print server NLMs rather than typing in the name).
15. If you have XAdmin 32 or XAdmin, click OK. If you
have JetAdmin, click Next two times, and then click
Finish. If you have WebXAdmin, click Submit.
16. Exit the configuration utility. You must now unload
the PSERVER NLM from your NetWare file server
console and then reload it in order for the changes to take
effect.
Configuring the Print Server and Print Queue using
PCONSOLE and XCONFIG (Remote Printer Mode)
To configure an TROY XCD print server for remote printer
mode operation using PCONSOLE and XCONFIG, first
make sure that you have V3.27 or later firmware (refer to
the self-test page or do a SHOW VERSION command from
the console). Then perform the following steps:
1. Make sure that the PSERVER NLM (NetWare
Loadable Module) is loaded on your file server.