Filter
Top Products
Management Methods 3-3
block of IP addresses, you may use any unique
address between 192.168.254.1 and
192.168.254.254 (this is a reserved range of Class C
addresses for private networks that are not
connected to the Internet per RFC 1918; note that
you must also assign the print server an IP address
in this range). You may also use a subnet mask of
255.255.255.0 with no gateway address. If you
have more than one LAN adapter card, select the
one you want to use for TCP/IP.
- Click on the TCP/IP folder icon under "Filter" on
the left side of the XAdmin screen.
- Click on the Search button (the leftmost button) or
select Devices and then Search Active Devices
from the menu bar.
- If you have a DHCP, BOOTP, or rarp server (or if
the print server already has an IP address from some
other source), the print server should appear in the
list of configured print servers. If this is the case,
skip to step 4.
- If the print server does not have an IP address, then
click on the Setup Unconfigured Devices button
(the third from the left) or select Devices and then
Setup Unconfigured Devices from the menu bar.
This will display the unconfigured print servers
listed by their Ethernet address (MAC Address).
Double click on the desired print server to configure
it.
- Enter the IP address, subnet mask, and gateway and
click OK.