Filter
Top Products
C-8 Reloading the Firmware
Downloading through the Serial Port (All
Models Except Pony Print Server Plus)
The print server can be downloaded from a PC connected to
the serial port via the XMODEM protocol. To do this, first
make sure that you have Switch 1 in Console mode (OFF)
and that the PC can communicate successfully with the print
server using terminal emulation mode (for example, through
a program like QLII or PCTERM). Then type in the
following commands in response to the Local> prompt:
SET LOAD ENABLE
Type EXIT to exit console mode. The print server will then
reboot. You will get a series of messages displayed on the
terminal; press RETURN at any time and then type:
SET LOAD XMODEM
in response to the Boot> prompt. You will get the message
"You may begin your XModem transfer now." Set your PC
terminal emulation program to send a file using the
XMODEM protocol with the file name XJET.BIN. The
print server will then download the XJET.BIN file.
Obtaining Firmware Updates
To get the latest firmware updates, go to the Tech Support
pages of the TROY XCD web site (http:/
www.troyxcd.com). Alternatively, you may obtain the
firmware from the TROY XCD FTP server
(ftp.troyxcd.com) in the firmware directory. Log in
under the user name anonymous with your e-mail address as the
password.