Filter
Top Products
2-4 Installation
position will conserve energy by drawing less power from the
printer.
Note: With V3.22 or earlier firmware (included with
XConnect II and XConnect II Lite print servers shipped from
TROY XCD prior to September, 1995), switches 2 and 3
must both be in the OFF position for 10baseT operation or in
the ON position for 10base2 operation.
Switch 4 (Console/Serial Printer)
This switch defines whether the serial port will be used for a
console terminal or a serial printer. Leave switch 4 in the
default OFF position if you want to use the serial port for a
console terminal.
Figure 2-2
XConnect 100 Switch and LEDs
Link OK LED
Test LED
100baseTX LED
Power Connector
Parallel Port 2
Test Switch
Console/
Serial Port 2
Serial Port 1
Parallel Port 1
100baseTX/
10baseT
Connector
Serial ports are 9-pin male D-connectors
XConnect 100 Front View
XConnect 100 Rear View