Filter
Top Products
4-14 TCP/IP Network Configuration
administrator before assigning an IP address to avoid
conflicts with other devices. If your network does not
have an officially assigned block of IP addresses, you
may use any unique address between 192.168.254.1 and
192.168.254.254 (this is a reserved range of Class C
addresses for private networks that are not connected to
the Internet per RFC 1918; note that you must also
assign your host computer an IP address in this range).
The IP address can be set in his can be done in any of
the following ways:
1. XAdmin32
2. HP JetAdmin
3. DHCP
4. The UNIX arp and ping commands
5 Reverse Arp (rarp)
6. BOOTP
7. DEC NCP, NCL, or ccr utilities
8. TROY XCD XCONFIG NetWare utility
9. XConnect II or XConnect 100 serial port
The easiest way to configure the IP address is using
either XAdmin32 or JetAdmin as described in Chapter
3. The remaining configuration methods are described
in the following paragraphs.
Important Note: The IP address you assign to the
print server must be on the same logical network as
your host computers (e.g., if your host has an IP address
of 192.189.207.3, the TROY XCD print server should
have an IP of 192.189.207.x, where x is an integer
between 1 and 254), or you must properly configure
your router to work with the TROY XCD print server.