Filter
Top Products
2-22 Installation
all protocols except LAT, TCP/IP, and AppleTalk) or service
2 (BINARY_P1, for LAT and TCP/IP). Refer to Appendix B
and the individual protocol chapters for additional
information on services.
To change the printer reset on a TROY XCD print server
with XAdmin, double click on the print server name, click on
the Services tab, double click on the desired service, and
then select the appropriate Printer Control String. With
WebXAdmin, click on Configure Service, and select the
desired service, choose the appropriate reset string, and then
click Submit.
Alternatively, you may use the print server console by typing
in the following command:
SET SERVICE
servicename
EOT
stringno
where "servicename" is the name of the service (do a
SHOW SERVICE command for a list of services) and
stringno is the number of the string. For example to use
string 3 (the PostScript CTRL-D reset) on the default
parallel port service, you would enter:
SET SERVICE BINARY_P1 EOT 3
Changing the Print Server Configuration
(Optional)
In addition to changing the printer reset string, you can
modify the TROY XCD print server configuration in a
number of other ways. The procedure and commands for
changing the configuration are described in Appendix A.