Filter
Top Products
TCP/IP Network Configuration 4-25
command to extract the software. Accept the default
directory to store the files. Follow the instructions in
the README files to install the software.
3. Run JetAdmin by typing jetadmin at the UNIX
prompt (on SunOS 4.xx systems, you use the hpnpcfg
program instead of JetAdmin, but the configuration
steps are similar).
4. Select item 1 (Configuration) and then select item 3
(Add printer to local spooler).
5. Enter the desired name for the TROY XCD print server
or IP address at the Enter the network
printer name/IP Name prompt.
Note: With versions of firmware earlier than 3.46, you
must enter the name (do not enter the IP address)
before configuring the print server name in the /
etc/hosts file, or in NIS or DNS. You will get a
message Unknown printer. Do you wish
to continue?". Enter "Y" to continue.
6. Select the printer type (for example, “HP LaserJet IIISi
Printers”).
7. If desired, change any of the configurable parameters
(note that the default queue name is the name of the
printer plus an “_” and a number (e.g., laser_1)). Then
enter 0 to configure the queue.
8. Answer “Y” at the “OK to Continue?” prompt. Exit the
JetAdmin utility by pressing RETURN and then “q”
twice.