Filter
Top Products
3-6 Management Methods
Newer OpenVMS systems use NCL instead of NCP. The
NCL command to connect to the print server console is:
SET HOST/MOP/CIRCUIT=
circuit
/ADD=
ethernetaddress
ULTRIX systems use the addnode and ccr commands as
follows:
addnode
xciiname
-c
circuit
-h
ethernetaddress
ccr
xcdname
where xcdname is an arbitrary name for the print server
(each print server on the network needs a unique name).
In all cases, you will get a message like Console Connected
or Remote Console Reserved when you are connected.
When you are connected, push RETURN or ENTER to get
the "#" prompt, enter the password ACCESS (it will not print),
and type anything in response to the Enter Username>
prompt. When you get the Local> prompt, you are ready to
enter commands.
Note: The commands available are generally a subset of the
ones used on the DECserver terminal server. Note that
unlike the DECserver, there is no distinction between the SET
and DEFINE commands or between the CLEAR and PURGE
commands. Instead, when you type CTRL-D to exit the
remote console, any of these commands take effect
immediately and the results are stored permanently (for
example, it is not necessary to enter both a SET and a
DEFINE to execute a command and save the results).
TELNET. To connect to the print server using TELNET on
UNIX, Windows NT, or most other TCP/IP systems, type:
TELNET
ipaddress