Filter
Top Products
• 1-11 • RMAN-QLS-002 rev. A
using label Vista
Equipment Required
1. A computer with the following minimum conguration:
• Pentium CPU
• 256 MB RAM
• 1.44 MB Floppy Drive
• 1 GB Hard Drive
• CD-ROM drive
• SVGA 14 in.monitor and SVGA card
• 2 Serial Ports
• USB Port
• Windows 95/9, NT or 2000
• Unit Test Software version 3.3 or higher installed with the “euro” conguration.
2. A bar code scanner, using either RS232 (serial) keyboard “wedge” or USB com-
munications. (Example: Symbol Model LS1908 series)
3. Serial Interface Cable part number AK18350-1 (or a Zebra approved equivalent).
4. Spare batteries, charger and test media specic to the printer. Refer to the table
in the “Tools and Supplies” topic in Section 2 of this manual.
5. Sensor calibration swatches: p/n AA15417-1 (gray) and p/n AA15417-2 (white)
These swatches are included in Spares Kit AN16753-029C.
Running The Software
CAUTION: DO NOT disconnect the communications cable at any time during the Unit Test
procedure unless prompted to do so by the software!
Certain replacement procedures in this manual will require running the test procedure to
verify a repair. It is recommended that you perform the entire unit test sequence for these
procedures to verify all printer functions after the replacement.
To Start
• Launch the Unit Test Application.
• Plug the Serial Interface Cable into the printer’s communication port.
• Follow the on-screen instructions.