Filter
Top Products
• 2-57 • RMAN-QLS-002 rev. A Repair Procedures
Platen and Gear As-
sembly
Peeler Bar
pLaten/geaR KitS, QL220/QL 220 pLuS an16972-008 & -009
1. Open the Media Cover.
2. Pry out the gear-end of the Platen and remove the Platen.
1. Align the ats on the Platen shaft with the hole in the Gear. The rib molded on
the Gear must face outboard.
2. Install the Platen with Gear in the Inner Cover as shown.
AN16792-009- Installing the Scraper
Units using linerless meda (PCC digit 8 = B or D): :Snap the Scraper into the Media Cov-
er. The pins on the Scraper t into the mounting holes for the Peeler Bar. The Scaper is
used with linerless media only.
AN16792-008- Installing the Peeler Bar
Units using meda with a liner (PCC digit 8 = A or C): Insert one end of the Peeler Bar
into the Inner Cover. Pivot the other end of the bar down and snap it into the Inner
Cover.
Scraper