Filter
Top Products
RMAN-QLS-002 rev. A Repair Procedures • 2-68 •
Install Label
Present Sensor
Option
Dress the long end
of the optional Label
Present Sensor Cable
through the Printer
Frame so that it emerges
as shown near J5 of the
MLB.
Plug the Sensor Cable into
J5 of the MLB as shown. The
Sensor Cable ex circuits in-
stalls in a zero insertion
force (ZIF) connector.
Pull the connector open to
insert the ex circuit. After
insertion insure the connec-
tor is closed to properly retain the
ex circuit.
Re-install the Upper Housing
1. Assemble the Upper Housing to the Print-
er, and secure it with the retained hardware.
At this time either the “D” rings, or the Carry-
ing strap which was supplied with the printer
should be reassembled. Note that the longer
screws are used in the corners of the Upper cover where the “D” rings or the
carrying strap was installed.
2. Re-install the QuickLink module. Plug the either the QuickLink module or the
module housing supplied with the printer into the Top Housing, and secure
with (1) screw through the battery compartment.
3. Install the Battery Pack.
4. Test the printer with the unit test software to properly calibrate the sensor and
verify its proper operation.
Insert the
Label Pres-
ent Sensor
Flex Cable
into J5 as
shown.