Filter
Top Products
• 2-101 • RMAN-QLS-002 rev. A Repair Procedures
If PCC digit 10 = S, set SW1 to OTHER CW (turn fully clockwise) (PIM-compati-
ble).
5. Install the Keypad cables per the table on the preceding page..
6. Install the Upper Housing and Lower Housing.
Compatibility Switch (SW1).
7. Install the Battery Pack.
8. Load the application. You must reload the printer’s original application les.
The application les can either be stored on your local system or can be down-
loaded from the factory’s database.
You must have authorization from Zebra to access the application files from the factory.
10. Calibrate the Sensors. Using the gray and white swatches, follow the on-screen
instructions on the unit test and set-up software to properly calibrate the sen-
sors.