Filter
Top Products
RMAN-QLS-002 rev. A Repair Procedures • 2-66 •
Install the Upper Housing
1. Assemble the Upper Housing assembly from the previous steps to the Print-
er, and secure it with the retained hardware. At this time either the “D” rings, or
the Carrying strap which was supplied with the printer should be reassembled.
Note that the longer screws are used in the corners of the Upper cover where
the “D” rings or the carrying strap was installed.
2. Install the QuickLink module. Plug the either the QuickLink module or the
module housing supplied with the printer into the Top Housing, and secure
with (1) screw through the battery compartment.
3. Install the Battery Pack.
4. Perform a two-key reset to verify that the unit has been correctly reassem-
bled.
“D” rings
(1) #4-40 x 3/8” Phil-
lips Hd.Screw
Upper Housing
and P.C. Cover as-
sembly
Use longer screws in this location
(2) places