Filter
Top Products
RMAN-QLS-002 rev. A Repair Procedures • 2-58 •
1. Open the Media Cover.
2. Pry out the gear-end of the Platen and remove the Platen.
1. Align the ats on the Platen shaft with the hole in the Gear. The rib molded on
the Gear must face outboard.
2. Install the Platen with Gear in the Inner Cover as shown.
pLaten/geaR KitS, QL320/320 pLuS- an16861-013 & an16861-
014
Platen
Gear 64P, 24T
Rib faces outboard
Insert this end rst.
Installing the Scraper
If the printer uses a scraper and it is not installed, snap the Scraper into the Media Cov-
er. The pins on the Scraper t into the mounting holes for the Peeler Bar. The Scaper is
used with linerless media only.
Scraper
You must use an ESD strap and work at a properly grounded workstation (antistatic mat or tray).
All electronic components must be placed on an ESD protective tray. If stored, any elec-
tronic components must be placed in antistatic bags.
NOTE: AN16861-035 and -036 are used on QL 320 units built prior to 1/20/03. Platen replacemnt proce-
dures are the same for both versions.