Filter
Top Products
AT-WA7500 and AT-WA7501 Installation and User’s Guide
127
Note
If any of the devices are also DHCP clients, you need to check the
Allow DHCP check box.
To configure 802.11a radio inbound filters
1. From the main menu, click 802.11a Radio > Inbound Filters. The
Inbound Filters screen appears.
2. For each frame type, check or clear each check box. For help, see the
next table.
3. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 46.
Table 40. 802.11a Radio Inbound Filter Descriptions
Parameter Description
Allow IAPP Determines if this radio accepts IAPP (Inter
Access Point Protocol) frames from other access
point station radios. The IAPP frames must match
Ethernet protocol 875c.
Allow Wireless
Transport Protocol
(WTP)
Determines if this radio accepts WTP frames
from end devices. The WTP frames must match
Ethernet protocol 875b.
Allow UDP Plus
(UDP/IP Port 5555)
Determines if this radio accepts UDP Plus frames
from end devices. The UDP Plus frames must
match the UDP network port 5555 on the DCS
30X, Allied Telesyn Gateway, or ARP.