Filter
Top Products
AT-WA7500 and AT-WA7501 Installation and User’s Guide
243
The access point is set to originate IP
tunnels but no there are no tunnel IP
addresses.
On the IP Tunnels screen,
Mode is set to Originate if
Root, but no IP addresses
have been added to the IP
Addresses screen. Either
change the mode or add
some addresses. For help,
see “Configuring IP
Tunnels” on page 148 and
“Configuring the IP
Address List” on page 149.
The address range for the DHCP server is
invalid.
On the TCP/IP Settings >
DHCP Server Setup
screen, the Low Address
and High Address are not
set correctly. For help, see
the Table 16, ”DHCP
Server Setup Parameter
Descriptions” on page 73.
The DHCP server is enabled with an
address range that is too large. If saved,
the range will be truncated to the
maximum number of addresses.
On the TCP/IP Settings >
DHCP Server Setup
screen, the Low Address
and High Address are not
set correctly. For help, see
the Table 16, ”DHCP
Server Setup Parameter
Descriptions” on page 73.
The DHCP server requires a non-zero IP
address.
For help, see “Configuring
the Access Point as a
DHCP Server” on page 70.
The DHCP server subnet mask is invalid. For help, see the Table 16,
”DHCP Server Setup
Parameter Descriptions”
on page 73.
The IAPP secret key has not been
changed from its default value.
Allied Telesyn
recommends that you
change the IAPP secret
key from the default for
security reasons.
The IP Address is zero. For help, see “Configuring
the TCP/IP Settings” on
page 65.
Table 68. Alphabetized List of Configuration Error Messages (Continued)
Configuration Error Message Additional Information