Filter
Top Products
AT-WA7500 and AT-WA7501 Installation and User’s Guide
287
Example: To change the inactive boot and data segments to active at the
next reboot, enter:
sdvars set setactivepointers both
sdvars set nextpoweruptime
Purpose: Sets the nextpoweruptime command to set the internal variable
nextpoweruptime to a countdown time so that when 0 is reached, the
access point will reboot. When the nextpoweruptime counter reaches 0,
the access point checks the value of the setactivepointers variable, takes
the appropriate action, and then reboots.
Note
If you need to terminate the reboot, you can set nextpoweruptime to
0 if it has not already been reached by the countdown. By resetting
nextpoweruptime to 0, the timer stops so the access point does not
reboot.
Syntax: sdvars set nextpoweruptime dd:hh:mm:ss
where dd:hh:mm:ss is how far in the future the reboot is to begin and
dd is days.
hh is hours.
mm is minutes.
ss is seconds.
Example:
To reboot the access point 2 hours from now, enter:
sdvars set nextpoweruptime 00:02:00:00