Filter
Top Products
AT-WA7500 and AT-WA7501 Installation and User’s Guide
59
Connecting Power Over Ethernet
The AT-WA7500 is powered by power over Ethernet. The AT-WA7501
can be powered by AC power or by power over Ethernet or both. For all
access points, you need a power bridge. For a list of the power bridges
that Allied Telesyn sells, contact your local Allied Telesyn representative.
This illustration shows how you connect the AT-WA7500 to a power bridge
with a typical Ethernet cable to run power over Ethernet.
Figure 19. Power Over Ethernet
To connect power over Ethernet
1. Install the power bridges. For help, see the documentation that
shipped with the power bridge.
2. Use an Ethernet cable to connect the power bridge to the Ethernet port
of the access point.
Power
Active
Power & Data Out
Data In
Main
Power bridge
To Ethernet
T
o AC