Filter
Top Products
Chapter 1: Getting Started
28
e. In the Primary service set SSID (Network Name) field, type the
SSID that matches the SSID of the end device radio. In this
example, the SSID is Manufacturing.
7. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 46.
8. Configure the access point to be a root access point. For help, see
“About the Primary LAN and the Root Access Point” on page 131.
9. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 46.
Example - Configuring an 802.11g WAP With No Roaming End
Devices
In this example, there is one 802.11g radio in the access point and there
are two 802.11g radios (802.11g Radio-1 and 802.11g Radio-2) in the
WAP. Wireless end devices only communicate with the WAP; they are not
allowed to communicate directly with the access point.
Figure 11. 802.11g WAP with No Roaming End Devices
Ethernet
Access
point
Host
WAP