Filter
Top Products
Configuring IP
Table 6.8: CLI Display of Global IP Configuration Information – routing switch (Continued)
This Field... Displays...
Policies
Index The policy number. This is the number you assigned the policy when
you configured it.
Action The action the routing switch takes if a packet matches the
comparison values in the policy. The action can be one of the
following:
• deny – The routing switch drops packets that match this
policy.
• permit – The routing switch forwards packets that match this
policy.
Source The source IP address the policy matches.
Destination The destination IP address the policy matches.
Protocol The IP protocol the policy matches. The protocol can be one of the
following:
• ICMP
• IGMP
• IGRP
• OSPF
• TCP
• UDP
Port The Layer 4 TCP or UDP port the policy checks for in packets. e
port can be displayed by its number or, for port types the routing
switch recognizes, by the well-known name. For example, TCP port
80 can be displayed as HTTP.
Note: This field applies only if the IP protocol is TCP or UDP.
Operator The comparison operator for TCP or UDP port names or numbers.
Note: This field applies only if the IP protocol is TCP or UDP.
Th
USING THE WEB MANAGEMENT INTERFACE
You cannot display global IP configuration information using the Web management interface.
Displaying IP Interface Information
To display IP interface information, use one of the following methods.
USING THE CLI
To display IP interface information, enter the following command at any CLI level:
HP9300(config)# show ip interface
Interface IP-Address OK? Method Status Protocol
Ethernet 1/1 207.95.6.173 YES NVRAM up up
Ethernet 1/2 3.3.3.3 YES manual up up
6 - 83