Filter
Top Products
Advanced Configuration and Management Guide
Port 2
IP sub-net 2
IPX network 2
AppleTalk cable range 200
AppleTalk zone “CTP”
6208M-SX
Ports 5 - 8
IP sub-net 2
IPX network 2
AppleTalk cable range 2
AppleTalk zone “CTP”
6308M-SX
Port 1
IP sub-net 1
IPX network 1
AppleTalk cable range 100
AppleTalk zone “Prepress”
Layer port-based VLAN 333
Ports 5 - 8
Port 5
Layer port-based VLAN 222
Ports 1 - 4
Ports 2 - 4
IP sub-net 1
IPX network 1
AppleTalk cable range 100
AppleTalk zone “Prepress”
Port 1
Figure 16.9 Port-based VLANs 222 and 333
To create the two port-based VLANs shown in Figure 16.9, use the following method.
USING THE CLI
HP6208(config)# vlan 222 by port
HP6208(config-vlan-222)# untag e1 to 4
HP6208(config-vlan-222)# vlan 333 by port
HP6208(config-vlan-333)# untag e5 to 8
HP6208(config-vlan-333)# write memory
Syntax: vlan <vlan-id> by port
Syntax: untagged ethernet <portnum> [to <portnum> | ethernet <portnum>]
EXAMPLE:
Figure 16.10 shows a more complex port-based VLAN configuration using multiple switches and IEEE 802.1p
VLAN tagging. The backbone link connecting the three switches is tagged. One untagged port within each port-
based VLAN on 6208M-SX A connects each separate network-wide Layer 2 broadcast domain to the routing
switch for Layer 3 forwarding between broadcast domains. The STP priority is configured to force
6208M-SX A to be the root bridge for VLAN BROWN. The STP priority on 6208M-SX B is configured so that
6208M-SX B is the root bridge for VLAN GREEN.
16 - 14