Filter
Top Products
Configuring VRRP and VRRPE
Table 12.2: CLI Display of VRRP or VRRPE Summary Information (Continued)
Master addr The IP address of the router interface that is currently the Master for
the VRID.
Backup addr The IP addresses of the router interfaces that are currently Backups
for the VRID.
VIP The virtual IP address that is being backed up by the VRID.
This Field... Displays...
USING THE WEB MANAGEMENT INTERFACE
You cannot display the summary view using the Web management interface. Use the Web management
procedure in “Displaying Detailed Information”.
Displaying Detailed Information
To display detailed VRRP or VRRPE information, use either of the following methods.
USING THE CLI
To display detailed information for a routing switch, enter the following command at any level of the CLI:
HP9300(config)# show ip vrrp
Total number of VRRP routers defined: 1
Interface ethernet 1/6
auth-type no authentication
VRID 1
state master
administrative-status enabled
mode owner
priority 255
current priority 255
hello-interval 1 sec
advertise backup: disabled
track-port 2/4
This example is for a VRRP Owner. Here is an example for a VRRP Backup.
HP9300(config)# show ip vrrp
Total number of VRRP routers defined: 1
Interface ethernet 1/5
auth-type no authentication
VRID 1
state backup
administrative-status enabled
mode non-owner(backup)
priority 100
current priority 100
hello-interval 1 sec
dead-interval 3.600 sec
current dead-interval 3.600 sec
preempt-mode true
advertise backup: enabled
backup router 192.53.5.3 expires in 00:00:03
next hello sent in 00:00:02
track-port 3/2
12 - 21