Filter
Top Products
Advanced Configuration and Management Guide
Configuration Rules for SRP
• Virtual interfaces cannot be assigned as track ports.
• The keep-alive-time value must be set to the same value on both the active and standby router when both
routers are connected to the same sub-net.
• The router-dead-time parameter must be set to the same value on both the active and standby routers when
both routing switches are connected to the same sub-net.
Enable SRP on the Routing Switch
Before configuring SRP to provide redundancy for a routing switch, you must enable the feature on the routing
switch.
USING THE CLI
To enable SRP on a routing switch, enter the following command:
HP9300(config)# router srp
USING THE WEB MANAGEMENT INTERFACE
To enable SRP on a routing switch:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Select the Enable radio button next to SRP.
3. Click the Apply button to apply the change to the device’s running-config file.
4. Select the Save
link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.
NOTE: All SRP configurations are implemented using a single configuration panel of the Web management
interface. Given this, all other configuration steps, other than enabling the feature, are shown in a separate
section at the end of this chapter rather than interspersed with CLI examples.
13 - 8