Filter
Top Products
Configuring VLANs
HP9300-C(config-vif-4)# vlan 4 name Bridged_ALL_Protocols
HP9300-C(config-vlan-4)# untag ethernet 3/1 to 3/8
HP9300-C(config-vlan-4)# tag ethernet 4/1 to 4/2
HP9300-C(config-vlan-4)# spanning-tree
HP9300-C(config-vlan-4)# vlan 7 name Rtr_BB_to_Bldg.2
HP9300-C(config-vlan-7)# tag e4/1
HP9300-C(config-vlan-7)# no spanning-tree
HP9300-C(config-vlan-7)# router-interface ve5
HP9300-C(config-vlan-7)# vlan 6 name Rtr_BB_to_Bldg.3
HP9300-C(config-vlan-6)# tag ethernet 4/2
HP9300-C(config-vlan-6)# no spanning-tree
HP9300-C(config-vlan-6)# router-interface ve6
HP9300-C(config-vlan-6)# int ve5
HP9300-C(config-vif-5)# ip addr 1.1.8.2/24
HP9300-C(config-vif-5)# ip ospf area 0.0.0.0
HP9300-C(config-vif-5)# ipx network 8 ethernet_802.3
HP9300-C(config-vif-5)# int ve6
HP9300-C(config-vif-6)# ip addr 1.1.5.2/24
HP9300-C(config-vif-6)# ip ospf area 0.0.0.0
HP9300-C(config-vif-6)# ipx network 5 ethernet_802.3
HP9300-C(config-vif-6)#
Configuring AppleTalk Cable VLANs
You can configure up to eight AppleTalk cable VLANs within a port-based VLAN.
To configure an AppleTalk cable VLAN, you create a port-based VLAN, then create up to eight cable VLANs within
the port-based VLAN. You create the AppleTalk cable VLAN by assigning a number to the VLAN, optionally
naming the cable VLAN, assigning ports from the port-based VLAN, and specifying the router interface (virtual
interface) on which the routing switch will send and receive traffic for the cable VLAN.
All the ports in an AppleTalk cable VLAN are within the same AppleTalk cable range. The routing switch switches
traffic within the VLAN and routes traffic between VLANs.
Configuration Guidelines
Use the following guidelines when configuring AppleTalk cable VLANs:
• Up to eight AppleTalk cable VLANs are supported in a protocol-based VLAN. Each VLAN must be numbered
from 1 – 8.
• Each AppleTalk cable VLAN can have only one router interface. The router interface must be a virtual
interface.
• The AppleTalk cable VLANs cannot overlap. Thus, you cannot use the same port in more than one AppleTalk
cable VLAN.
• You must add the ports to the AppleTalk cable VLAN using the static option. You cannot use the dynamic or
exclude options.
16 - 29