Filter
Top Products
Advanced Configuration and Management Guide
Configuring MSDP Peers
Use the following CLI method to configure an MSDP peer.
USING THE CLI
To configure an MSDP peer, enter a command such as the following at the MSDP configuration level.
HP9300(config-msdp-router)# msdp-peer 205.216.162.1
Syntax: [no] msdp-peer <ip-addr>
USING THE WEB MANAGEMENT INTERFACE
You cannot configure MSDP using the Web management interface.
Displaying MSDP Information
You can display the following MSDP information:
• Summary information – the IP addresses of the peers, the state of the routing switch’s MSDP session with
each peer, and statistics for Keepalive, Source Active, and Notification messages sent to and received from
each of the peers
• Peer information – the IP address of the peer, along with detailed MSDP and TCP statistics
• Source Active cache entries – the Source Active messages cached by the routing switch
Displaying Summary Information
To display summary MSDP information, use the following CLI method.
USING THE CLI
To display summary MSDP information, enter the following command at any level of the CLI:
HP9300(config-msdp-router)# show ip msdp summary
MSDP Peer Status Summary
KA: Keepalive SA:Source-Active NOT: Notification
Peer Address State KA SA
In Out In Out
206.251.17.30 ESTABLISH 3 3 0 640
206.251.17.41 ESTABLISH 0 3 651 0
Syntax: show ip msdp summary
This display shows the following information.
MSDP Summary Information
NOT
In Out
0 0
0 0
This Field... Displays...
Peer Address The IP address of the peer’s interface with the routing switch
State The state of the MSDP router’s connection with the peer. e state
can be one of the following:
• CONNECTING – The session is in the active open state.
• ESTABLISHED – The MSDP session is fully up.
• INACTIVE – The session is idle.
• LISTENING – The session is in the passive open state.
Th
9 - 32