Filter
Top Products
Configuring VLANs
7. Select the virtual interface from the Router_Interface pulldown list if you configured a virtual interface for
routing into and out of the VLAN.
8. Select the encapsulation type from the Frame_Type field’s pulldown list.
9. Enter the IPX network address of the VLAN in the Network field.
10. Specify the port that are members for the VLAN:
• Select Dynamic Port if you want the port membership to be dynamic. For information, see “Dynamic
Ports” on page 16-9.
• Click the Change Static Members button if you want to configure static ports. For information, see “Static
Ports” on page 16-10.
• Click the Change Exclude Members button if you want to explicitly exclude some ports. For information,
see “Excluded Ports” on page 16-10.
NOTE: All the ports must be members of the port-based VLAN that contains this IPX network VLAN. See
“Layer 3 Protocol-Based VLANs” on page 16-3.
11. Click the Add button (if you are adding a new VLAN) or the Modify button (if you are modifying an existing
VLAN) to save the change to the device’s running-config file.
12. Select the Save
link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.
NOTE: You also can access the dialog for saving configuration changes by clicking on Command in the tree
view, then clicking on
Save to Flash.
Configuring an AppleTalk Cable VLAN
1. Log on to the device using a valid user name and password for read-write access.
2. Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
3. Click on the plus sign next to VLAN in the tree view to expand the list of VLAN option links.
4. Click on the Protocol
link.
• If the device does not have any protocol VLANs, the Protocol VLAN configuration panel is displayed, as
shown in the following example.
• If at least one protocol VLAN is already configured and you are adding a new one, click on the AppleTalk
Cable link to display the AppleTalk Cable VLAN configuration panel.
• If you are modifying an existing protocol VLAN, click on the Modify button to the right of the row
describing the VLAN to display the configuration panel for the type of VLAN you are modifying. The
following example shows the AppleTalk Cable VLAN configuration dialog, used for configuring an
AppleTalk cable VLAN (not a protocol, IP sub-net, or IPX network VLAN).
16 - 55