Filter
Top Products
Advanced Configuration and Management Guide
This example is for VRRP. Here is an example for VRRPE:
HP9300(config-if-e1000-1/6-vrid-1)# show ip vrrp-extended brief
Total number of VRRP-Extended routers defined: 1
Interface VRID CurPri P State Master addr Backup addr VIP
1/6 1 255 P Init 192.53.5.2 192.53.5.3 192.53.5.254
Syntax: show ip vrrp brief | ethernet <portnum> | ve <num> | stat
Syntax: show ip vrrp-extended brief | ethernet <portnum> | ve <num> | stat
The brief parameter displays the summary information. If you do not use this parameter, detailed information is
displayed instead. See “Displaying Detailed Information” on page 12-21.
The ethernet <portnum> parameter specifies an Ethernet port. If you use this parameter, the command displays
VRRP or VRRPE information only for the specified port.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command displays VRRP or
VRRPE information only for the specified virtual interface.
The stat parameter displays statistics. See “Displaying Statistics” on page 12-26.
This display shows the following information.
Table 12.2: CLI Display of VRRP or VRRPE Summary Information
This Field... Displays...
Total number of VRRP (or VRRP-
Extended) routers defined
The total number of VRIDs configured on this routing switch.
Note: The total applies only to the protocol the routing switch is
running. For example, if the routing switch is running VRRPE, the
total applies only to VRRPE routers.
Interface The interface on which VRRP or VRRPE is configured. If VRRP or
VRRPE is configured on multiple interfaces, information for each
interface is listed separately.
VRID The VRID configured on this interface. If multiple VRIDs are
configured on the interface, information for each VRID is listed in a
separate row.
CurPri The current VRRP or VRRPE priority of this routing switch for the
VRID.
P Whether the backup preempt mode is enabled. If the backup preempt
mode is enabled, this field contains a “P”. f the mode is disabled, this
field is blank.
State This routing switch’s VRRP or VRRPE state for the VRID. The state
can be one of the following:
• Init – The VRID is not enabled (activated). f the state remains
Init after you activate the VRID, make sure that the VRID is also
configured on the other routers and that the routers can
communicate with each other.
Note: If the state is Init and the mode is incomplete, make sure
you have specified the IP address for the VRID.
• Backup – This routing switch is a Backup for the VRID.
• Master – This routing switch is the Master for the VRID.
I
I
12 - 20