Filter
Top Products
Configuring AppleTalk
USING THE CLI
HP9300(config)# interface e1/1
HP9300(config-if-1/1)# appletalk deny zone finance
HP9300(config-if-1/1)# int e1/3
HP9300(config-if-1/3)# appletalk deny zone finance
HP9300(config-if-1/3)# int e1/13
HP9300(config-if-1/13)# appletalk deny zone finance
HP9300(config-if-1/13)# int e1/15
HP9300(config-if-1/15)# appletalk deny zone finance
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
3. Click on the plus sign next to AppleTalk in the tree view to expand the list of AppleTalk option links.
4. Click on the Zone Filter
link.
• If the device does not have any AppleTalk zone filters, the AppleTalk Zone Filter configuration panel is
displayed, as shown in the following example.
• If an AppleTalk zone filter is already configured and you are adding a new one, click on the Configure
AppleTalk Zone Filter link to display the AppleTalk Zone Filter configuration panel, as shown in the
following example.
• If you are modifying an existing AppleTalk zone filter, click on the Modify button to the right of the row
describing the filter to display the AppleTalk Zone Filter configuration panel, as shown in the following
example.
5. Select the interface for which a zone filter is to be defined, from the port or slot/port pull down menu(s). In this
example, you are defining a zone filter for interfaces 1, 3, 13, and 15, all of which have membership in either
or both of the Marketing and Field Service zones.
6. Enter the name of the zone to which you are permitting or denying access. In this case, enter Finance.
7. Select either Deny or Permit. In this example, select Deny for interfaces 1, 3, 13, and 15.
8. Enable RTMP filtering to filter on a network basis. When RTMP filtering is enabled on an interface, the
denied network numbers are removed from the RTMP packet before it is transmitted out of the interface.
9. Click the Apply button to apply the changes to the device’s running-config file.
10. Select the Save
link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.
15 - 11